A loop tilting in a uniform field. Magnetic flux is how much field gets through a surface: Φ = B A cos θ, where θ is the angle between the field and the loop's normal — the line sticking out at right angles to its face, never the face itself. Hold the flux density and the area still and drag the angle: the flux falls to zero edge-on at 90° and comes back with the opposite sense past it. Nothing here changes with time, so no voltage is calculated anywhere.
θ is measured from the normal, not from the loop's plane. A loop lying flat across the field has θ = 0 and the most flux it can carry; turn it until the field skims past its face and θ = 90°, where nothing threads it at all.
The loop is drawn as the field sees it, so the shaded face is the area facing the field. One gold line through the face stands for 0.2 mWb of flux, so the line count is a counting aid and not a physical count. The field is uniform everywhere and the loop is flat and rigid.
Magnetic flux Φ = B A cos θ
1.000 mWb
Area facing the field A cos θ, size only
50.00 cm2
Angle factor cos θ
1.000
Field lines through the loop 0.2 mWb each
5
Flux density B0.200 T
Loop area A0.0050 m2
Most it could be1.000 mWb
Flux in webers1.000e-3 Wb
Angle0 deg from the normal
Which way it threadsout of the loop
Flux density B200 mT
Loop area A50 cm2
Angle from the normal0 deg
Rotate sweeps the angle 0 to 180 and back at about 30 deg/s, snapping to the 5-degree slider grid so every reading is one you can dial in by hand. At B = 0 the angle factor still reads 1.000 at 0 degrees: cos θ is geometry and knows nothing about the field.